Detroit-radiant-products-company QTS Series Manuel d'utilisateur télécharger pdf (Page 13)

Figure 3.3 • Heater Assembly

Assembly prior to hanging: With this method, the use of two saw horses or a raised table or bench

surface is beneﬁcial (the emitter assembly and reﬂector box may also be used).

1 Lay the emitter assembly (TP-6082) across the horses or bench with the exchanger connection

hanging bracket extended out over the edge (See Detail ‘A’) NOTE: Use of the foam shipping blocks

will help protect the emitter coating and reﬂectors.

2 Install the tube ﬂange gaskets (TP-6021B) onto the corresponding studs on the burner control box.

3 Align the nine (9) burner control box studs with the eight (8) holes located on the emitter plates and

the one (1) hole on the exchanger connection hanging bracket.

4 Install nine (9) 5/16 - 18 keps nuts provided, tightening evenly and torque to 20 ft-lb.

Reﬂector Sub-Assembly

1 On a ﬂat surface, lay out two reﬂectors (TP-6088) parallel to each other.

2 Place U-end reﬂector end cap (TP-6084A) at one end and burner reﬂector end cap (TP-6085A) at the

opposite end with the “over/under tabs” facing the reﬂector.

3 Move the reﬂector end caps into the reﬂector ends while aligning the “over tabs” (larger tabs with

holes) over the top of the reﬂector and the “under tabs” (smaller tabs with no holes) under the reﬂector

(see Detail B). This can be achieved by squeezing the reﬂector slightly to ﬁt into the end cap.

4 Properly secure reﬂector end caps to reﬂectors using #8-1/2” screws (TP-62) through the hole into the

reﬂector, being careful not to strip.

5 Repeat process with the remaining two reﬂectors.

Vent Cap

(WVE-GALV)

NOTE: Cut foam

1/4” from dip

Reﬂector (TP-6088) x4

Vent Adapter Fitting

(TP-6080)

Vent Pipe

(TP-6075)

Burner

Control Box

Exchanger Connection

Hanging Bracket

Tube Flange Gasket

x2 (TP-6021B)

Emitter

Assembly

(TP-6082)

Emitter Plates

U-End Reﬂector End Cap

(TP-6084A) x2

Burner Reﬂector

End Cap

(TP-6085A) x2

DETAIL ‘A’

DETAIL ‘B’

Note: Install last.

See page 14.

Tabbed

End

QTS Series

3.0 Installation • Heater Assembly

Heater Assembly

1 2 ... 8 9 10 11 12 13 14 15 16 17 18 ... 43 44

Commentaires sur ces manuels

Pas de commentaire

Detroit-radiant-products-company QTS Series Manuel d'utilisateur Page 13

Commentaires sur ces manuels

Produits connexes et manuels pour Four Detroit-radiant-products-company QTS Series