Detroit-radiant-products-company HLV Series Manuel d'utilisateur télécharger pdf (Page 30)

HLV Series

3.0 Installation • Burner Assembly and Mounting

Determine the mounting chain locations for hanging the burner control box.

Fasten beam clamp, screw hook or other type of suspension anchor to hanging point.

Attach S-Hook and #1 double loop chain (P/N: THCS) to anchor. Check that it is securely

connected.

Attach chain assemblies and S-Hooks to mounting brackets on the burner control box. Adjust chain

lengths until level and in straight alignment with radiant tubes (Figure 3.16).

Figure 3.16 • Burner Control Box Assembly • Side View

Burner Sight Glass

(bottom side of the tube)

Burner tube is in straight

alignment with 10 ft. Primary

Combustion Chamber

Figure 3.17 • Burner Control Box • End View

12”

16”

18”

5.5”

5”

3.5”

3”

8.1”

Burner box

mounting

bracket

Burner Assembly and Mounting

WARNING

Conditions such as wind drafts or other variables can cause movement of the heater and

may require it to be rigidly mounted. Avoid excessive movement and/or vibration of the

gas connection by rigidly mounting the burner control box. All remaining hanging points

should use chains to allow for expansion.

The heater must be independently supported and in no case shall the gas or electrical supply support

the weight of the heater.

1 2 ... 25 26 27 28 29 30 31 32 33 34 35 ... 51 52

Pas de commentaire

Detroit-radiant-products-company HLV Series Manuel d'utilisateur Page 30