Detroit-radiant-products-company QTD Series Manuel d'utilisateur télécharger pdf (Page 4)

WARNING

DETROIT RADIANT PRODUCTS COMPANY

21400 HOOVER ROAD - WARREN, MI

RE-VERBER-RAY INFRA-RED RADIANT TUBE HEATER

FOR INDOOR (Non-Residential) INSTALLATION ONLY.

Class IIIA Permanent Label

NOT FOR RESIDENTIAL USE

(586) 756-0950 - www.drp-co.com

Line Voltage:

Control Voltage:

AMPS - Starting:

AMPS - Running:

120V - 60Hz

1.5

1.1

Manifold Pressure:

Maximum Inlet Pressure:

Minimum Inlet Pressure:

Serial No.: 1001DETRXXXXXXXXX 0001

MODEL NO.

QTS - 80P

Heater Type

Version:

3/10

INPUT BTU/H

80,000

FOR USE WITH

Propane Gas

10.0 Inches

14 Inches

11.0 Inches

W.C.

Warning!

Unit must be

mounted level

Rear Panel

F/N: LL01 - Clearance Safety Tag

(Afﬁx adjacent to heater’s thermostat)

Rating Plate

F/N: LLTB036

SERVICE ACCESS PANEL

1. Turn off gas & electricity.

2. Remove service access panel screws.

3. Slide panel downward.

SAMPLE

LLTB014-5M-6/13 (CDS)

Avoid Equipment Failure.

Do Not Rotate

Burner Assembly.

Mount Level

INSTALLER

F/N: LLTB014

Mount Level

SERVICE ACCESS PANEL

FAN, BURNER & IGNITER COMPARTMENT

1. Turn off gas & electricity.

2. Remove 1/4 inch sheet metal screws.

3. Remove cover by lifting top.

CAUTION: HOT SURFACE.

KEEP COVER IN PLACE. REMOVE FOR SERVICE ONLY.

F/N: LLTB035

(Located on top panel)

F/N: LLAC

Air Metering Oriﬁce

Air Metering Orifice

DO NOT REMOVE

TP-3014 3"

SAMPLE

F/N: LLTB037

F/N: LLTB018 (Natural Gas)

F/N: LLTB019 (LP Gas)

QTD Series

1.0 Introduction • Data Labels and Their Locations

Data Labels and Their Locations

All labels must be maintained on the radiant tube heater and should be replaced if they become illegible.

Contact either your local distributor or the product manufacturer for obtaining replacement signs or labels.

It is important to provide warnings to alert individuals to potential hazards and safety actions. In locations

used for the storage of combustible materials, post a placard “specifying the maximum permissible

stacking height to maintain the required clearances from the heater to the combustibles” near the heaters

thermostat or in absence of such thermostats in a conspicuous location. Contact Detroit Radiant Products

or an authorized dealer for Clearance Safety Limit Signs or for Clearance Safety Limit Tags (one tag is

provided with each heater).

Improper installation, adjustment, alteration, service or maintenance can cause

property damage, serious injury or death. Read and understand, the installation,

operating and maintenance instructions thoroughly before installing or servicing this

equipment. Only trained, qualiﬁed gas installation and service personnel may install or

service this equipment.

1 2 3 4 5 6 7 8 9 ... 43 44

Commentaires sur ces manuels

Pas de commentaire

Detroit-radiant-products-company QTD Series Manuel d'utilisateur Page 4

Commentaires sur ces manuels

Produits connexes et manuels pour Four Detroit-radiant-products-company QTD Series